HP OfficeJet Pro 8640 All-in-One Printer Installation and Setup

Initially check the products in the packing box and compare with the listed items because the products may vary by countr/region.  If you are trying to do HP OfficeJet Pro 8640 All-in-One Printer Installation and Setup for the first time, remove the printer from the box, connect the power cord, change your control panel settings, install ink cartridges, load paper into the tray and align the ink cartridge. For more detailed instructions, follow the below given instructions for easy installation.

  1. Unpack the printer from the box and start with HP OfficeJet Pro 8640 All-in-One Printer Installation and Setup process.
  2. Remove all the tapes, stickers and packing materials from outside and inside the printer.
  3. To remove the packing materials from the inside of the printer, open the scanner lid and lift it.
  4. You should also remove the packing materials from output tray for easy installation and check whether you have dispersed all the materials as they may damage your printer while running.
  5. Close the scanner lid and output tray. Send the packing materials to recycle.
  6. Do not connect the USB cable when you are connecting the power cord and installing the software
  1. Connect one end of the power cord to the rear of the printer and other end to power source. Switch on the printer
  2. On the printer control panel, set your preferences by clicking on language and country/region. Click Yes to confirm your choice
  3. You can also change the date and time. Click Yes to cofirm
  4. Install the cartridges by opening the cartridge access door and remove the packing material before HP OfficeJet Pro 8640 All-in-One Printer Installation and Setup.
  5. Turn the ink cartridge so that the ink cartridge contacts face downward, and then match the label color with the color dot on the carriage.
  6. Place the ink cartridge in its slot and repeat the same steps for all the other cartridges.
  7. Load the paper into the tray by pulling the input tray towards you and adjust the paper width guide.
  8. Place a stack of paper in the input tray until it stops and the paper width guide should rest against the edges of the paper.
  9. The printer control panel asks you to align the printer. Pull out the tray extender, and then touchOK.
  10. The alignment page gets printed and eject it from the printer.
  11. Lift the scanner lid and place the alignment page with the print side down on the scanner glass.
  12. Position it accordingly aroun the glass, close the scanner lid and click Scan
  13. Install the printer software by visiting hp.com/OJ8640. Wait for instructions and finish the HP OfficeJet Pro 8640 All-in-One Printer Installation and Setup Process.